Scheme - Non Destructive Testing - Ultrasonic Testing



  • Level I
  • Level II
  • Level II (Direct Access)

REQUIREMENTS

Course Code
  • RSM/UT1
Duration
  • 8 Days
Examination
  • Theory and Practical
Additional Information
  • N/A
Prerequisites/Entry Requirements
Who Should Attend
  • Applicable to fresher's and experienced inspection professionals who require theoretical understanding of Ultrasound and how it applies in verifying the condition of material during fabrication and in service inspection.
Course Content
  1. Principles of Ultrasonic Testing
  2. Ultrasonic Testing Equipment and Probes and Calibration Using Reference Block
  3. Plotting System
  4. Lamination Detection and Thickness Measurement
  5. Reporting Procedures
  6. Codes, Standards and Procedures
  7. Manufacturing Process and Discontinuities

REQUIREMENTS

Course Code
  • RSM/UT2
Duration
  • 12 Days
Examination
  • Theory and Practical
Additional Information
  • N/A
Who Should Attend
  • Applicable to fresher's and experienced inspection professionals who require theoretical understanding of Ultrasound and how it applies in verifying the condition of material during fabrication and in service inspection.
Course Content
  1. Principles of Ultrasonic Testing
  2. Ultrasonic Testing Equipment and Probes and Calibration Using Reference Block
  3. Plotting System
  4. Lamination Detection and Thickness Measurement
  5. Detection of Flaws in Welds
  6. Reporting Procedures
  7. Codes, Standards and Procedures
  8. Manufacturing Process and Discontinuities

REQUIREMENTS

Course Code
  • RSM/UTD
Duration
  • 20 Days
Examination
  • Theory and Practical
Additional Information
  • N/A
Prerequisites/Entry Requirements
Who Should Attend
  • This course is suitable for all inspection personnel including both entry level and expe-rienced operators, engineers and surveyors who require a thorough and comprehensive introduction to ultrasonic testing of welded joints.
Course Content
  1. Principles of Ultrasonic Testing
  2. Ultrasonic Testing Equipment and Probes and Calibration Using Reference Block
  3. Plotting System
  4. Lamination Detection and Thickness Measurement
  5. Detection of Flaws in Welds
  6. Reporting Procedures
  7. Codes, Standards and Procedures
  8. Manufacturing Process and Discontinuities